New GPS Land Meter Land Measuring Instrument Mountain Area
Measurement
Circle machine load area measurement Of GPS land meter
Circle machine load measurement function is used to measure area
around the land, set the position of the land meter in the vehicle
and the nearest distance of the ground boundary,and then measure
the boundary around the region.Then measuring around the boundary
of the land.
① At the Circle machine load in parameter setting,press the
▲▼button to set the edge distance;
② After setting is completed,press the "Start" to return main
interface;
③ Press the▲▼button switch function to “Circle machine load”in the
main interface;
④ In the main interface,press the【Start】button to measure at
starting point .
⑤ Press the【Stop】button to pause measurement and view data after
agricultural machinery work is completed；If the measurement is not
completed,press the 【Start】 button again to continue the
measurement. If the measurement is completed,press "Start" to save
the data.
•Round-trip machine load
Round-trip machine load is used to measure the area of agricultural
machinery back and forth work,put the Land meter in the middle of
the vehicle width as far as possible,set the width of the front-end
operation of agricultural machinery,and then carry out back and
forth work measurement.
① At the Round-trip machine load in parameter setting,press the
▲▼button to set the width.
② After setting is completed,press the "Start" to return main
interface.
③ Press the▲▼button switch function to“Round-trip machine load”in
the main interface；
④ Press【Start】button at the starting point to start the measurement
at the beginning of the work.
⑤ Press the【Stop】button to pause measurement and view data after
agricultural machinery work is completed；If the measurement is not
completed,press the 【Start】 button again to continue the
measurement. If the measurement is completed,press "Start" to save
the data.
Note: clicking "data" here will not display real-time data, and the
current measured area must be calculated by clicking "pause".
• Length and width area measurement
① In the main interface,press the ▲▼to switching function to
“Length and width”.
② At the starting point A press the【Start】button to measure,and
press the【Enter】button to save the point A,go to the inflection
point B,and press the【Enter】button to save the point B,go to the
inflection point C,press the【Enter】button to save point C.
③ Press the【Stop】button to end measurement and view data,and press
"Start" to save the data.
Note: if you want to end the measurement before 3 points are
collected,Press the【Stop】button to pause the measurement.
